Realme GT Neo 2 bypass pattern lock tool
unbrick is a process to repair a device that was bricked, within Realme GT Neo 2 users face two types of brick- soft brick and hard brick.
Soft brick: in this stage device is stuck or freezes on the boot logo or animation due to any software/ firmware issue.
hard brick: in this stage device completely goes dead and does not show any sign of boot for example logo or animation, even fastboot or recovery mod. it shows only the 9008 USB COM driver /device when we connect it to the computer
so if your Realme GT Neo 2 has any soft or hard brick issue then you can fix it by following the below Instructions.
Specification:
The Realme GT Neo 2 is a solid contender as a mid-range gaming smartphone. The Qualcomm Snapdragon 870 processor offers plenty of raw performance and the phone’s cooling system does a good job of sustaining that performance during long gaming sessions.
The Neo Green finish of the GT Neo 2 does stand out quite a bit and the bright neon green color can be a bit too much for some buyers. Thankfully, Realme offers two other subtle colorways that also look equally unique.
Battery life with the 5,000mAh battery is excellent and easily lasts a day and a half even with some gaming sessions. The dual speakers are quite loud and clear and make for an immersive experience while gaming and are loud enough for watching movies as well.
Camera performance is a mixed bag at best. While daylight performance is good, it's not consistent. Low light camera performance isn’t great and the same can be said about the video. And this also means that the GT Neo 2 is not an all-rounder.
Unbrick Realme GT Neo2 Process:
- Download the unbrick tool from above
- Install the qcom 9008 USB driver on your computer
- Run tool
- Connect Phone in EDL Mod
- once COM is detected mark Method 1 & click the Connect loader button
- under the Firmware Flash locate extracted ofp Firmware
- Click ‘FIRMWARE FLASH‘
- wait until success, done
Bypass pattern lock on Realme GT Neo 2
- Download unbrick tool from above
- Install the qcom 9008 USB driver on your computer
- Run tool
- Connect Phone in EDL Mod
- once COM is detected mark Method 1 & click Connect loader button
- then Click ‘Factory Reset
- once done disconnect the device, press all three buttons for 1 Min
0 Comments
Do Not Send SPAM Link !!!!