Translate

VIVO Y17s Preloader and Scatter File Free Download

VIVO Y17s Preloader and Scatter File Free Download

VIVO Y17s is a MediaTek device Preloader file is allowed you to flash and unlock your device by any tool. the file is tested and check on many devices, today I have a link for download the file and fixed your device and recover from FRP, Userlock and flash device.



Download Link


  • VIVO Y17s Preloader + Scatter File: Download

Flashing VIVO Y17s Using SP Flash Tool


  1. Download and Install Mediatek Driver Autoinstaller

    • If Mediatek Driver is already installed on your computer, skip this step.
    • Otherwise, download and install the driver.
  2. Download Stock ROM

    • Download the Stock ROM (firmware) for your Mediatek Device.
    • Extract the downloaded firmware on your computer.
  3. Download and Extract SP Flash Tool

    • Download SP Flash Tool and extract it on your computer.
    • You should see the following files after extraction:
      • SP Flash Tool Extracted Files
  4. Launch SP Flash Tool

    • Open flash_tool.exe to launch the tool.
  5. Load Scatter File

    • Click on the Scatter-Loading Button.
    • Locate and select the Scatter File from the firmware folder.
    • Click the Open button.
  6. Start Flashing Process

    • Click on the Download Button to begin the flashing process.
  7. Connect Device to Computer

    • Connect your Mediatek Device to the computer using a USB cable (ensure the device is powered off).
    • After connecting, press the Volume Down or Volume Up key for the tool to detect the device.
  8. Flashing Process

    • Once the computer detects your device, the flashing process will start automatically.
  9. Completion

    • A Green Ring will appear at the end of the flashing process.
    • Close SP Flash Tool and disconnect the device.
  10. Success

  • You have successfully flashed or installed Stock Firmware on your Mediatek device.

Removing FRP (Factory Reset Protection) on VIVO Y17s

  1. Open SP Flash Tool

    • Launch the SP Flash Tool on your computer.
  2. Load Scatter File

    • Load the scatter file for your device.
  3. Bypass the Auth

    • Bypass the authorization requirement.
  4. Go to Format Tab

    • Select the Format tab in SP Flash Tool.
  5. Manual Format Flash

    • Choose the "Manual Format Flash" option.
  6. Set Format Addresses

    • Enter the following addresses:
      • Begin Address [HEX]: 0x7508000
      • Format Length [HEX]: 0x100000
  7. Start Formatting

    • Click on the Start button to begin the formatting process.

Post a Comment

0 Comments