Samsung FRP Bypass using browser Free 2025
With this Samsung FRP Bypass WEB tool, you can bypass Factory Reset Protection (FRP) on Samsung devices with a security patch older than August 2022, directly in your web browser—without the need for third-party software or server-side processing.
The only requirement is the Samsung USB Driver, which must be installed on your computer. You can download it from the official Samsung website.
Known Issues & Fixes
Issue: "The device has been lost" error when sending DEBUGLVC command
Cause:
- The
AT+DEBUGLVC
command changes the USB configuration, causing the device to disconnect.
Solution:
- Refresh the browser page.
- Reconnect the device.
- Press the button again and continue the process.
File information
File Name: Samsung FRP Bypass using a browser
File Size: Online
File Type: Free
Password: No password
How to Use
Requirements
✔ A Chromium-based browser (Chrome, Edge, Brave, Opera, etc.)
✔ Installed Samsung USB drivers
✔ A USB cable to connect your device to the PC
Steps to Bypass FRP
Enable Test Mode on the Device
- Open the Emergency Dialer on your Samsung device.
- Dial
#0#
to enter Test Mode.
Connect the Device to Your PC
- Use a USB cable to connect your phone to your computer.
Run the Bypass Tool
- Open the online demonstration site or run the code locally.
- In the WebSerial section, click "Connect".
- In the popup, select your device (e.g., CDC Abstract Control Model (ACM) (COM16)).
Execute the Bypass Commands
- Click the buttons in order as shown in the tool.
- Once done, click "Disconnect".
Use WebUSB for the Final Steps
- Repeat the same process in the WebUSB section.
- Click "Connect", then press the buttons in sequence.
Reboot the Device
- Click the "Reboot" button.
- Your device will restart and should land on the lock screen or system UI.
Final Steps
- On some models, you may still need to complete the initial setup.
- If required, follow the on-screen instructions.
0 Comments
Do Not Send SPAM Link !!!!