Itel A60s (A662LM) Dead Boot Repair + EMMC Change Without EMMC Dump File

🔧 Itel A60s (A662LM) Dead Boot Repair + EMMC Change Without EMMC Dump File

If you're searching for a solution to the dead boot issue on the Itel A60s (model A662LM) and need a solution that doesn't require an EMMC dump file, you're in the right place. 

Also read :TECNO BG6 Spark GO 2024 Dead Fix Firmware

✅ Key Features of This Method:

• No need for an original EMMC dump file
• Works with new/blank EMMC chips
• 100% tested on Itel A60s (A662LM)
• Includes pre-prepared file for direct programming

⚠️ Symptoms of Dead Boot:

• Device not powering on
• No charging indication
• Not detected in SP Flash Tool or other flashing tools
• Blank screen even with key combinations

🧰 What You Need:

1. Working PC/Laptop
2. EMMC Programmer (e.g., UFI, Easy JTAG, etc.)
3. Itel A60s (A662LM) Dead Boot Repair File
4. Basic soldering/reballing skills (if changing EMMC)

Also read :Infinix Note 30 5G X6711 Touch Not Working – 100% Fix

📥 Download the File:

You can download the full repair package here:
👉 Itel A60s Dead Boot Repair File [2.1 GB]

Also read :Realme 10 RMX3630 Dead Boot Repair Fix ROM [Scatter Firmware]

🛠️ Repair Procedure:

🔁 1. Replace the EMMC (if needed)

• Remove the faulty EMMC chip from the board.
• Reball or replace it with a compatible new EMMC.
• Place the new EMMC on the PCB and solder properly.

📤 2. Write Dead Boot Repair File

Also read :Samsung G973N U6 Fix ROM Dual SIM [Reset No Lost Network]

• Open your EMMC programmer software (UFI Box / Easy JTAG).
• Connect the EMMC to the box.
• Write the provided Dead Boot Repair file directly to the new EMMC.
• The file includes preloader + partition data necessary to boot.
• No full dump or original data is required.

🔌 3. Reassemble & Boot

• Re-solder the EMMC to the board if needed.
• Reassemble the phone.
• Power it on — it should now boot or at least enter download mode.
• Flash full firmware via SP Flash Tool to complete recovery.

📌 Notes:

• Always backup if you still have access to the old EMMC.
• This method is intended for technicians with basic EMMC handling skills.
• If device still doesn’t power on, check for hardware shorts or PMIC issues.